IMCAS ESP 2

•  Unique coating that is specially formulated to seal vacuum leaks.

•  Can be used on turbine condensor gaskets, turbine rupture discs, strainers, manways, hot well covers, condensate line expansions joints, as well as many other areas that present possible vacumm leaks.

 

FULL PRODUCT INFORMATION

 

 

Category: Tags: , , Product ID: 2727

Description

 

     

 

IMCAS ESP 2 is a unique coating that is specially formulated to seal vacuum leaks. It can be used on turbine condensor gaskets, turbine rupture discs, strainers, manways, hot well covers, condensate line expansions joints, as well as many other areas that present possible vacumm leaks.

INCAS ESP 2 will bond tightly to rubber but will release from metal with a little coaxing. Temperature in areas used should not exceed 250°F.

Outstanding Features

  • Total bonding
  • Easy to apply
  • Bonds to rubber
  • No halogens or PTFE
  • Liquid applied
  • No Elemental Sulfur

Container sizes

5 gallon

Color

White

Coating type

Ethylene Elastomer Thermoplastic

 

Application

Application
Surfaces must be dry, free of dirt or loose debris, free of oils, greases or any substances that will interfere with bond. IMCAS ESP 2 is applied straight out of the can after 2 minutes of gentle low speed mixing or stirring. Apply the product using brush or roller. It is only necessary to touch the vacuum leak with IMCAS ESP 2. The vacuum will draw it in and cause it to plug the leak.

Spray equipment can be used to reach areas. Caution is advised in using spray equiment. Airless type equipment must be used. The following equipment specifications must be used: 30:1 pump ration or higher. A minimum 3/8″ hose with as short of a run of hose as possible. A #37 tip is recommended.

Clean up
Clean tools and equipment with xylene or toluene solvent. Do not allow any solvent to contact IMCAS ESP 2 that has been applied.

Limitations
Do not apply to wet or frozen surfaces that are saturated with moisture. Shelf life is 2 years when stored in a factory sealed container between 45°F and 90°F. This product is flammable. Keep away from sources of heat, sparks, and flames. Use only EP rated equipment.

Precautions
Read the container label warning and Safety Data Sheet (SDS) for important health and safety information prior to the use of this product.

Maintenance

If a surface becomes dirty, wash with a mild soapy water solution. If an area becomes nicked or cut, re coat with IMCAS ESP 2.

KEEP AWAY FROM CHILDREN AND PETS

For additional information, contact the Andek Technical Department

 

Technical Data
VOC  350 gms/liter
Moisture Vapor Transmission  0.01 perms ASTM E-96
Tensile Strength  864 psi ASTM D-412
Elongation 550% ASTM D-412
Flexibility at Low Temperature 180° Bend (10°F) ASTM C-711
Shore ‘A’ Hardness 75 ASTM D-2240
Weatherometer (5000 hours) Pass ASTM G-23
Viscosity Approx 15,000 cps ASTM D-446
Solids 63% (B.W.); 55% (B.V.) ASTM D-1044
Flashpoint
105°F (Closed Cup) FTMS 141A (M4293)
Density Approx 9 lb/gallon ASTM D-1475