POLAFLOOR P.U.R. BRUSHABLE combines the properties of silicon carbide, Kevlar* and urethane chemistry to produce a high-performance engineered coating. An ultra-high performance three-part urethane floor coating, it is designed for the most severe interior and exterior service. POLAFLOOR P.U.R. BRUSHABLE has exceptional resistance to most industrial chemicals and provides a tough, wear-resistant surface that resists both impact and abrasion.


Outstanding Features:


Various Uses:


Recommended for:

Can be used over concrete, insulation, most metals, mineral composites and other surfaces.





All surfaces to be coated must be clean, dry and completely free of loose particles, grease, oils, or any substance that would interfere with proper bond. All preparation work including substrate repairs and expansion joints must be completed prior to application. If PUR BRUSHABLE is to be applied over a waterproofing membrane, the membrane should be thoroughly inspected to insure that it has completely set and is devoid of pinholes or interruptions. Add the Part A to the Part B while stirring thoroughly with a drill-type stirrer. Mixing must be continued for 3 minutes total. The mix should then be poured back and forth between the 2 component cans twice, then stirred a further minute. The Part C should be stirred into the mixture immediately and stirred for 2 minutes until a uniform paste consistency is achieved. Careful attention to detail will help to produce the desired result in appearance and performance. Once mixed, PUR BRUSHABLE has approximately 40 minutes working time at 70°F and will have developed an initial cure suitable for foot traffic within 24 hours. The floor may be placed into full service within 48 hours.


Clean up:

Equipment may be cleaned with toluene, xylene, or aromatic naptha before the PUR BRUSHABLE has hardened.



Do not apply to frozen or damp surfaces. Do not apply if the application cannot be protected from precipitation for at least 4 hours. Full chemical resistance properties are not achieved until 5 days after application. Foot traffic may not resume until 24 hours after application. Only skilled coating applicators should use this product.



If an area of PUR Brushable becomes damaged, it should be mechanically removed down to the substrate. The edges surrounding the patch should be sanded and primed with Polaprime 21 and new PUR BRUSHABLE may be applied.



Read the container label warning and Material Safety Data Sheet (MSDS) for important health and safety information prior to the use of this product. 

Keep out of reach of children and pets.

For additional information, contact our Technical Department.


Technical Data:



Notice: The information presented herein is based on tests and data that Andek Corporation believes to be reliable. It is intended for use by technically qualified personnel at their own discretion and risk. Since conditions of handeling and use are beyond our control, we make no warranties, express or implied, and assuming no liability in connection with any use of this information. Nothing herein is to be construed as a license to operate or a recommendation to infringe any patent.