MATERIAL SAFETY DATA SHEET

U.S. Department of Labor

Occupational Safety & Health Administration

SECTION I - IDENTIFIERS

MANUFACTURER: Andek Corporation

ADDRESS: 850 Glen Avenue, Moorestown, NJ 08057

TELEPHONE: (856) 786-6900 or emergency (800) 424-9300 (CHEMTREC)

TRADE NAME: Polaprime 2

CHEMICAL FAMILY: Acrylic Copolymer Emulsion

SECTION II - COMPOSITION

COMPONENT CAS # APPROX % TLV

Calcium Silicate 1344-95-2 10.0

Calcium Carbonate 75-20-7 1.7

Barium Metaborate Monohydrate 13701-59-2 4.5

Dispersant (nonionic)/Defoamer (Silicon Emulsion) 744-21-3 0.5

Acrylic Copolymer and Polyvinyl Diene Chloride/

Ethylene Acetate 25085-46-5 49.9

Water 7732-18-5 Balance

KNOWN CARCINOGENS OR MUTAGENS - TYPE & DEFINITION

None

SECTION III - PHYSICAL DATA

BOILING POINT (F) 212° SPECIFIC GRAVITY (H20=1) 0.95

VAPOR PRESSURE 68 PERCENT, VOLATILE BY VOLUME 65

VAPOR DENSITY (AIR=1) As Water EVAPORATION RATE (N.B.A.=1) 1.0

SOLUBILITY IN WATER 100% pH 8.0

APPEARANCE & ODOR

White liquid with an ammoniacal odor.

SECTION IV - FIRE & EXPLOSION HAZARD DATA

FLASH POINT (METHOD USED): >200°F (ASTM D50).

FLAMMABLE LIMITS: N/A

EXTINGUISHING MEDIA: N/A

SPECIAL FIRE FIGHTING PROCEDURES: N/A

UNUSUAL FIRE & EXPLOSION HAZARDS: None

DECOMPOSITION PRODUCTS: Oxides of carbon, barium, boron, calcium, silicon, and halogens.

SECTION V - HEALTH HAZARD DATA

EFFECTS OF OVEREXPOSURE:

SKIN: May irritate skin.

EYES: Contact is unpleasant; vapor may irritate.

BREATHING: Not considered harmful; slight ammoniacal odor may annoy some individuals.

SWALLOWING: Although non-toxic, entry into throat may cause choking.

FIRST AID PROCEDURES:

SKIN: While wet, wash with water. If dry, use proprietary hand cleaner, followed by hot water.

EYES: Flush with plenty of water and seek medical attention.

BREATHING: Remove to fresh air.

SWALLOWING: Induce vomiting and call a physician.

SECTION VI - REACTIVITY DATA

STABILITY: Stable.

INCOMPATABILITY (MATERIALS TO AVOID): Strong oxidizers.

HAZARDOUS DECOMPOSITION PRODUCTS: None

HAZARDOUS POLYMERIZATION: Will not occur.

CONDITIONS TO AVOID: Freezing will coagulate material.

SECTION VII - SPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:

Cover with a layer of sand or suitable absorbent material or wash away with water.

WASTE DISPOSAL METHOD:

In accordance with local, state and federal regulations.

SECTION VIII - SPECIAL PROTECTION INFORMATION

RESPIRATORY PROTECTION (SPECIFY TYPE): Unnecessary if used outdoors.

EYE PROTECTION: Chemical splash goggles.

SKIN PROTECTION: Neoprene rubber or polyethylene gloves.

OTHER PROTECTIVE EQUIPMENT: Coveralls and/or rubber apron, rubber shoes or boots.

PERSONAL HYGIENE: Wash thoroughly after use.

SECTION IX - SPECIAL PRECAUTIONS

PRECAUTIONS TO BE TAKEN IN HANDLING:

Avoid prolonged contact with skin. Do not consume food or beverage while handling. Do not allow

to freeze; otherwise material will be unusable and require disposal.

SECTION X - TRANSPORTATION INFORMATION

PROPER SHIPPING NAME: Paint

HAZARD CLASS: None

PACKING GROUP: N/A

ID #: N/A

RQ: N/A

TRANSPORT LABELS REQUIRED: This material is not regulated by the D.O.T.

This information accumulated herein is believed to be accurate but is not warranted to be, whether

originating with the company or not. Recipients are advised to confirm, in advance of need, that the

information is current, applicable and suitable to their circumstances.

REVISED: JANUARY 2005