ROOFDX GOLD

ROOFDX GOLD is an extremely tough, metallic, rubber-like, waterproofing coating that has a stunning golden finish with exceptional elasticity. This remarkable "liquid gold" coating can be used over all common roofing substrates and will give the appearance of gold leaf at a fraction of the cost. ROOFDX GOLD may be sealed with a topcoat of Clearcoat 44 to provide an extra shiny, brilliant appearance.

OUTSTANDING FEATURES:

§ Can be used over BUR, rubber, copper, aluminum, tin, concrete, wood, masonry and others

§ Saves time, money and labor over installing gold leaf

§ Unlike gold leaf, produces a fully adhered, seamless, high density, waterproof membrane

§ Provides imaginative design possibilities

§ Protects substrate against rust, corrosion, UV damage, acid rain and fungal attack

§ Easy to apply straight out of the container by brush, roller or airless spray

§ May be used on vertical, pitched and horizontal surfaces and withstands ponding water

§ Remains flexible, tough and weatherproof at low temperatures and will not flow at high temperatures

§ Will not re-emulsify or wash away with rainwater

§ Scrubbable and easy to clean

§ Can easily be recoated

§ Warrantied for 10 years

All surfaces to be treated must be clean, dry and free of loose debris that may interfere with proper bond. Surfaces that have previously been coated should be examined carefully and tested for adhesion to the substrate. This can be accomplished by applying a strip of scotch tape to the coated surface. The tape should be thoroughly pushed into full contact and then pulled away at a 90 degree angle. Observe the adhesive surface for any dislodged coating particles. If the tape has pulled away a significant quantity of coating, or if it has loosened the coating from the substrate, the coating should be removed. Loose coating should be thoroughly removed by abrasion, water jetting or other available technique. Some coatings that are firmly bonded but have reticulated (mud cracked) and the edges lifted will need abrading to present a uniform, smooth surface for coating. Some very inert surfaces, such as epoxy, will require abrading and/or a special primer coat. coat.

ROOFDX GOLD is applied straight out of the can after 2 minutes of low speed mechanical stirring. Apply the product using brush, roller, or airless spray technique. The product should be applied in two coats at an overall rate of 50 square feet per gallon, achieving a wet film thickness of 30 mils or 15 mils per coat. Clean tools and equipment with xylene or toluene before ROOFDX GOLD begins to dry.

READ THE ENTIRE ROOFDX GOLD MATERIAL SAFETY DATA SHEET BEFORE APPLICATION APPLICATION.

Wear safety equipment, such as splash goggles and rubber gloves, when handling this product. Hands should be protected with a barrier cream and cleaned with a proprietary hand cleaner. Avoid contact with skin and eyes. In case of eye contact, flush with clear water for 15 minutes. In case of contact with eyes, seek immediate medical attention in addition to flushing. Do not ingest. In case of ingestion, contact a physician immediately.

Do not apply to frozen or saturated surfaces. Cold temperatures will slow down the drying time. Do not apply if precipitation is forecast within 4 hours after application.

NOTICE: The information presented herein is based on tests and data that Andek Corporation believes to be reliable. It is intended for use by technically qualified personnel at their own discretion and risk. Since conditions of handling and use are beyond our control, we make no warranties, express or implied, and assume no liability in connection with any use of this information. Nothing herein is to be construed as a license to operate or a recommendation to infringe any patent.