CLEARCOAT 44 is a single component, moisture cure, aliphatic clear urethane coating. It produces a tough, glossy, hard wearing and chemically resistant surface. CLEARCOAT 44 may be used alone as a clear, tough gloss coat over masonry, concrete, vinyl, wood, or other approved substrates. If specified, a range of textured aggregates is available to provide a traction enhanced surface. CLEARCOAT 44 was tested for conformance to industrial standards to meet the approval of the sealant waterproofing and restoration institute (SWR Institute). This product was validated using third party verification to certify that it performed above industry standards. CLEARCOAT 44 is also used over bright metal surfaces to maintain their appearance and prevent tarnishing
Outstanding Features:
- May be used over concrete, wood, masonry, vinyl, bright metals and other approved surfaces
- Produces a fully adhered, seamless, high density, clear urethane coating
- Protects your investment by increasing the effective service life of the substrate
- Reduces dusting and is salt & chemical resistant
- May be applied by brush, roller or airless spray
- Resists penetration by oils, fuels and process fluids
- Sets quickly and develops strength rapidly
- Accommodates rubber tire mounted vehicular traffic
- Scrubbable and easy to clean
- Provides long term resistance to wear and abrasion
- Ideal for horizontal, pitched and vertical surfaces
- Remains tough and flexible at low temperatures
- Single component formula means no measuring or mixing
- Warrantied for 5 years
Specifications:
Application:
Caution! Read this entire data sheet before continuing.
All surfaces to be coated must be clean, dry, and completely free of loose particles, oils, grease, or any substance that would interfere with proper bond. CLEARCOAT 44 may be applied over products such as Polafloor Colorcoat at any time after the Colorcoat has been thoroughly dry for at least 1 hour. If overcoating a painted surface, check compatibility first, as some paints may bleed color or be lifted by solvents. CLEARCOAT 44 may be applied by brush or airless spray technique in a thin, even coat. Care should be taken to avoid creating foam or trapping air bubbles which may later result in pinholes or hazing. If traction enhancement is required, iron-free sharp white quartz sand may be broadcast into the wet CLEARCOAT 44. After the first coat has thoroughly dried with the embedded sand, a second coat of CLEARCOAT 44 is applied to thoroughly encapsulate the aggregate. Sized and graded sharp white quartz sand is available from Andek Corporation. Equipment may be cleaned with toluene or xylene while the CLEARCOAT 44 is still wet.
Limitations:
Do not use below 35°F. Do not apply if the application cannot be protected from precipitation for 4 hours. Shelf life is 12 months when stored in proprietary containers between 45°F and 95°F. Open containers will exhibit a reduced shelf life due to moisture absorption.
Maintenance:
Damaged areas should be thoroughly sanded and cleaned and then recoated. Dirt accumulations may be removed with warm water and detergent.
Precautions:
WARNING! This product is flammable. Avoid sparks, open flame, and use EP rated equipment. Use only in well ventilated areas. Do not ingest. In case of ingestion, do NOT induce vomiting and seek medical attention immediately. Avoid contact with skin and eyes. In case of contact, flush with clear water for 15 minutes. In case of contact with eyes, seek medical attention in addition to flushing.
Keep out of reach of children and pets.
For additional information, contact our Technical Department.
Technical:
Notice: The information presented herein is based on tests and data that Andek Corporation believes to be reliable. It is intended for use by technically qualified personnel at their own discretion and risk. Since conditions of handling and use are beyond our control, we make no warranties, express or implied, and assume no liability in connection with any use of this information. Nothing herein is to be construed as a license to operate or a recommendation to infringe any patent.