Features | Various Uses | Specifications | Application | Clean Up | Maintenance | Limitations | Precautions | Technical Data

POLAFLOOR PD is an air drying, moisture cured, single component polyurethane coating for application to heavy plank, wood block and industrial concrete floors.  It produces a surface that is very wear-resistant and is unharmed by most industrial chemicals.  POLAFLOOR PD cures to an attractive semi-gloss finish and is available with aluminum oxide granules or sharp quartz silica to provide a highly traction-enhancing surface.

 

Outstanding Features:

 

Various Uses:

 

Specifications:

 

Application:

Caution! Read this entire data sheet before continuing.

All surfaces to be coated must be clean, dry, and completely free of loose particles, oil, grease, or any substance that would interfere with adhesion.  Surfaces may be cleaned by emulsifiable degreaser, solvent, heavy duty detergent, sand blasting, or other convenient form of surface preparation.  Remove all traces of cleaning agent and allow the surface to dry before beginning work.  Previously coated surfaces must be tested for soundness and compatibility with POLAFLOOR PD.  It may be necessary to brush blast previous coatings to provide a key for proper bonding.

POLAFLOOR PD may be applied by roller, brush, or squeegee brush.  If using a roller, a medium pile roller with a solvent-resistant pile and core is recommended.  If using a brush, carry the POLAFLOOR PD to the surface on the brush.  No moisture can be present on equipment or the substrate when using POLAFLOOR PD. 

Two coats are recommended for optimum appearance and durability.  Apply subsequent coats. When the prior coat is touch-dry, but not more than 24 hours between coats.  If aggregate is used to increase traction, broadcast it into the first coat while it is still wet. 

 

Clean up:

Clean equipment immediately after use in xylene or toluene.  It is important that cleaning takes place before the POLAFLOOR PD dries.

 

Limitations:

Do not use below 35°F.  Shelf life is 6 months when stored in factory-sealed containers.  Coated surfaces with direct exposure to sunlight will experience a loss of gloss and a slight change in color.

 

Precautions:

Warning!  This product is flammable.  Keep away from sparks and open flames.  Use manual spray equipment or EP (explosion proof) rated equipment.  Keep container tightly closed when not in use. 

Do not ingest.  In case of ingestion, do NOT induce vomiting and seek immediate medical attention.  Keep away from skin and eyes with rubber gloves, full coveralls, and eye goggles.  In case of contact flush with clear water for 15 minutes.  In case of contact with eyes, seek immediate medical attention in addition to flushing.  Individuals with sensitivities to handling isocyanates are advised not to handle this product.

Keep out of reach of children and pets.

For additional information, contact our Technical Department.

 

Technical Data:

 

 

Notice: The information presented herein is based on tests and data that Andek Corporation believes to be reliable. It is intended for use by technically qualified personnel at their own discretion and risk. Since conditions of handeling and use are beyond our control, we make no warranties, express or implied, and assuming no liability in connection with any use of this information. Nothing herein is to be construed as a license to operate or a recommendation to infringe any patent.