Features | Specifications | Application | Clean Up | Limitations | Maintenance | Precautions | Technica Data

POLASEAL M-A is a siloxane-based, single component waterproofing treatment for use on brick, stucco, block, concrete, stone, clay tile, slate, and exposed aggregate concrete.  It penetrates the substrate and quickly cures to lock itself into the pore structure. POLASEAL M-A produces an incredibly durable barrier against the action of weather, pollutants, de-icing chemicals, and ultra-violet radiation, without altering the surface appearance.

 

Outstanding Features:

 

Specifications:

 

Application:

POLASEAL M-A is designed for application over untreated masonry surfaces. It is advisable to test any previously treated, painted or stained surface prior to application to insure compatibility. A test application is also recommended if exact coverage figures are desired. Surface to be treated must be clean and free of loose debris, dirt, mildew, oils and grease. All repairs and patchings should be allowed to age for 3 days prior to treatment. A dry surface is advantageous since it will allow maximum penetration of product into substrate. Apply POLASEAL M-A by brush, roller or low pressure spray technique. Low pressure spray is recommended where practical for rapid and thorough application.  For a vertical surface, start at the top and work down.  Fully saturate the surface with POLASEAL M-A. When spraying, apply enough material to generate a slight rundown of product. For a horizontal surface, start at one edge and work backward toward the opposite edge. Apply enough POLASEAL M-A to saturate the surface. Single coat coverage is suitable for nearly all applications.  Extremely porous substrates or areas that have been experiencing heavy water infiltration may require a second coat. Apply a light second coat while the first coat is damp. 

 

Clean up:

Clean tools immediately after use with water and detergent.

 

Limitations:

Do not apply to frosted or saturated surfaces. Do not apply if precipitation is forecast within 8 hours. Do not spray in strong wind conditions. Protect adjacent surfaces, including shrubbery, from overspray. Overspray may damage raw copper or aluminum surfaces. Remove any overspray from glass, metal or vinyl surfaces within 4 hours by wiping with thinner or mineral spirits, followed by wiping with glass cleaner. Store product between 38°F and 95°F.

 

Maintenance:

If a treated surface becomes dirty, low pressure wash with water or a soapy water solution.  Rinse with clear water spray.

 

Precautions:

Do not ingest.  In case of ingestion, get immediate medical attention.  Avoid contact with skin and eyes.  In case of contact, flush with clear water for 15 minutes. 

For contact with eyes, get medical attention in addition to flushing. Wear rubber gloves, safety goggles, and coveralls when using this product. Intended for outdoor use only. 

Keep out of reach of children and pets.

For additional information, contact the Andek Technical Department.

 

Technical Data:

Andek Polaseal MA

 

Notice: The information presented herein is based on tests and data that Andek Corporation believes to be reliable. It is intended for use by technically qualified personnel at their own discretion and risk. Since conditions of handling and use are beyond our control, we make no warranties, express or implied, and assume no liability in connection with any use of this information. Nothing herein is to be construed as a license to operate or a recommendation to infringe any patent.